Detailed Guide: Fitting Your 4D Gel Plates
Properly fitting your 4D gel plates is essential not only for aesthetic reasons but also for legal compliance and safety. Follow these detailed instructions and tips to ensure your plates are securely and legally displayed on your vehicle.
Before fitting your new plates, thoroughly clean the surface where they will be attached. Use a mild detergent and water to remove any dirt, grease, or debris. Ensure the surface is dry before proceeding.
2. Positioning:
Carefully position your 4D gel plates on the vehicle, ensuring they are centered and aligned correctly. Use a measuring tape or ruler to ensure equal spacing from the edges of the vehicle.
3. Marking:
Once you have determined the correct position for your plates, use a pencil or masking tape to mark the placement on the vehicle. This will serve as a guide when attaching the plates.
4. Attachment Method:
There are various methods for attaching 4D gel plates, including using sticky tabs. Choose the method that best suits your preferences and the requirements of your vehicle. We would advise strongly not to drill, in most cases the screw holes will be under your digits, which will void the plates warranty if you drill through them.
Apply sticky tabs to the back of the plates and firmly press them onto the vehicle surface. Ensure the tabs are evenly spaced and firmly attached.
Screws:
If using screws, carefully drill holes into the vehicle surface according to the markings made earlier. Use screws provided or appropriate screws for your vehicle type.
5. Legal Requirements:
Ensure your 4D gel plates are legally displayed according to local regulations. This includes:
-
Font and Size: Use a font and size that complies with DVLA standards. Avoid decorative fonts that may impede readability. There should only be one font used , which is Charles Wright.
-
Visibility: Ensure the plates are clearly visible and unobstructed by any accessories or modifications.
6. Secure Attachment:
After attaching the plates, press firmly along the edges to ensure a secure bond between the plates and the vehicle surface. Check for any signs of movement or looseness and reattach if necessary.
7. Final Check:
Once the plates are attached, step back and inspect them from various angles to ensure they are straight, evenly positioned, and securely attached. Make any adjustments if needed.
By following these detailed instructions and tips, you can ensure your 4D gel plates are securely and legally fitted to your vehicle, enhancing its appearance while staying compliant with regulations.